0

Set M10 Single

SKU: PVM101V
EAN No.:4260377560996
54.90 €

Inc. 19% VAT in addtion shipping costs.
Weight: 0.14 kg


Secures the rear wheel with Rohloff solid axle by using a M10 x 1 thread.

Secures the rear wheel  with SRAM DD3 solid axle by using a M10 x 1 thread. Does not fit older models.

Secures the rear wheel with NuVinci n360 solid axle by using a M10 x 1 thread.

Thanks to numerous suggestions from our customers and support from Rohloff we have been able to expand our product range and are now able to offer you a Pitlock locking system for Rohloff solid axles. If wide aluminum dropouts are installed on your bicycle, we recommend using the Pitlock M10 / Mono set, that secures one side of the Pitlock solid axles. The M10/ double set contains two locks and can therefore be installed on both sides of the Rohloff solid axles.

content:

1 closure M10, 1 Pit key for solid axles, 1 code card

 

installation guide (solid axle)


important:

The protruding thread is supposed to stick out of the dropout for approximately 14 mm. The locking ring requires a space (supporting surface) of 15 mm in the radius or rather 30 mm in the diameter around the thread, so that the Pitlock lock can be installed safely. In case the protruding thread is too short, it is necessary to use an axle stub with a long threaded axle (available from Rohloff, article no.: 8235L Axle Plate TS OEM).

attention:

Unfortunately, the system for solid axles (SH38, SH90 and M10) can not be produced with the same coding as the M5 system.

The coded nut of solid axles is much bigger than the coded nut for M5 axles.

As a result, the PIT key of the solid axle systems must of course be bigger.

 

 

Our solid axle systems are combinable!

So, if you have a Shimano solid axle dynamo hub on your front wheel and a Rohloff solid axle or a Shimano Alfine/ Nexus on your rear wheel, it is possible to secure these two hubs with the same coding.